Guide · Homeowners · 3 min read · Updated 17 November 2026
How Much Does Penetrating Damp Treatment Cost in the UK?
Short answer
Penetrating damp treatment costs depend on where the water gets in. Gutter and downpipe repairs cost £120–£450, repointing £45–£90 per m², small render patches from £250 and a full elevation re-render £50–£95 per m². Chimney flashing and pointing repairs run £350–£1,200, and basement waterproofing £90–£180 per m². Scaffolding is often the biggest extra on work above ground floor.
Penetrating damp repair prices
Penetrating damp is not a single problem with a single price. It is water getting in from outside through a defect in the building envelope, and the repair is whatever closes that route. A blocked gutter can be fixed in an hour, while a wall of failed render may need a full elevation stripped and replaced with scaffolding in place for weeks. That is why the first and most important cost is a proper diagnosis.
The table below shows typical 2026 guide prices for the most common repairs. They cover labour and materials but not scaffolding unless stated, and not internal redecoration once the wall has dried.
| Repair | Typical price | Notes |
|---|---|---|
| Gutter and downpipe repair | £120–£450 | Clearing, resealing joints, refixing brackets |
| Repointing a wall | £45–£90 per m² | Lime or cement mortar, excluding scaffolding |
| Render patch repair | from £250 | Cutting out and patching a small cracked or hollow area |
| Full elevation re-render | £50–£95 per m² | Strip and replace render, plus scaffolding |
| Chimney flashing and pointing | £350–£1,200 | Re-dressing lead, repointing, fitting a cap |
| Basement waterproofing | £90–£180 per m² | Cavity drain membrane or tanking with drainage |
What drives the cost
Height and access are usually the biggest factors. Work that can be reached from the ground or a short ladder is cheap. Anything at first-floor level or above normally needs a tower or scaffolding, and on a busy street the scaffolder may need a licence from the local highway authority before it can be erected on the pavement. Scaffolding can easily cost more than the repair it gives access to, which is why it makes sense to combine jobs while it is up.
Materials matter too. Lime mortar and lime render cost more and take longer to apply than cement, but they are usually the correct choice on solid-walled older buildings. Matching existing brick, stone or render colours on a prominent elevation also takes extra care.
Check whether the quote includes clearing up, disposal of old materials and any making good of paving or paths disturbed during the work.
- Height of the defect and need for scaffolding or a tower
- Highway licence for scaffolding on a public pavement
- Lime or cement materials and colour matching
- Size of the area affected and number of separate defects
- Internal replastering and redecoration once the wall dries
Worked examples
A damp patch on a bedroom ceiling below a leaking cast-iron gutter joint might be solved with a gutter repair in the £120 to £450 range. Once the wall dries, the internal patch can usually be sealed and repainted.
A damp chimney breast in an upstairs bedroom of a Victorian terrace is more involved. The cause is often failed lead flashing, eroded pointing on the stack or rain entering an uncapped flue. A combined flashing, pointing and capping job costs £350 to £1,200, depending on access. An exposed gable wall with cracked, hollow cement render might need re-rendering at £50 to £95 per m², plus scaffolding, which on a typical gable can run into several thousand pounds overall.
Why cheap fixes often fail
The most common waste of money is treating the inside of a wall for a problem that starts outside. Internal waterproof coatings, tanking slurries and stain-blocking paints can hide penetrating damp for a while, but water keeps entering the wall and eventually finds a way out somewhere else. Silicone sealant smeared over cracks in render or around window frames is another short-lived fix that can trap water behind it.
Another common mistake is assuming damp near the ground is rising damp and paying for injection when the real cause is a leaking downpipe or splashback from a hard path. Get the cause identified properly before spending money on any treatment.
Paying for a short inspection by an independent surveyor or an experienced roofer is usually money well spent where the cause is unclear.
Internal making good after the repair
Once the source of water has been fixed, the inside of the wall needs time to dry before it is redecorated. A thin plaster wall may dry in a few weeks, while a thick solid wall soaked over several winters can take months. Painting too soon traps moisture and the stain reappears, which makes it look as though the repair has failed when it has not.
Where plaster is sound, a stain-blocking primer followed by breathable emulsion is usually enough. Where it is blown, crumbling or salt-stained, it should be cut out and replaced. Budget for this separately from the external repair, because it is often quoted by a different trade. Keep the room heated and ventilated while the wall dries to speed things up.
Saving money without cutting corners
Group work together. If a roofer is putting up scaffolding to repair a chimney, ask them to check and clear gutters, inspect valleys and look at the top of walls at the same time. Schedule external work in the drier months, when mortar and render cure properly and wet-weather delays are less likely. Get at least two quotes and make sure each one specifies the materials, the area and who arranges any licence.
Finally, keep up with simple maintenance. Clearing gutters each autumn and checking downpipe joints costs far less than any repair.
Questions people also ask
Does home insurance cover penetrating damp?
Most home insurance policies exclude damage caused by gradual water ingress and lack of maintenance, which covers most penetrating damp. Damage from a sudden event, such as a storm dislodging roof tiles, may be covered. Read your policy wording and report storm damage promptly, because delays can affect a claim.
How much does scaffolding add to damp repairs?
It depends on the height, length and complexity of the scaffold and how long it stays up. On a single elevation of a two-storey house it can be a significant part of the total. Where scaffolding sits on a public pavement, a highway licence is usually required. Combining repairs makes the scaffolding cost go further.
Do I need to replaster after fixing penetrating damp?
Not always. Once the water source is fixed and the wall has dried, sound plaster can often be sealed and redecorated. Plaster that is crumbling, blown or heavily stained will need replacing. On solid-walled older homes, lime plaster is often the best choice for the replacement.
Written and checked by the Penetrating Damp Treatment team. Read our editorial policy.
More guides
How to Find the Source of Penetrating Damp
To find the source of penetrating damp, map the damp patch inside, then look at the outside wall and roof directly opposite and above it. Check…
Penetrating Damp in Cavity Walls: Causes and Repairs
Cavity walls are designed to stop rain crossing from the outer to the inner leaf, but damp can still get through when the cavity is bridged. Common…
Penetrating Damp in Rented Homes: Landlord and Tenant Rules
In most residential tenancies the landlord is responsible for fixing penetrating damp, because it comes from defects in the structure and exterior…
Penetrating Damp: What You Can Fix Yourself and What You Can't
Simple ground-level jobs such as clearing a single-storey gutter, refixing a downpipe, clearing weep holes and keeping soil away from walls are…
Get a free penetrating damp treatment quote
Tell us what you need and we'll come back with a clear price.
Request a quote